Shopping Cart is Full

You cannot add any additional items to the Shopping Cart

Close Window

Site will log you out


You are leaving the BEHR® Consumer website. You will be logged out.



Ask an Expert by Email


Thank you,
Your email has been sent to our experts.



See all Interior paint how-to »

How to Create a Venetian Plaster Finish

Skill:  Intermediate DIY'er

BEHR PREMIUM PLUS with Style® Venetian Plaster produces an attractive and elegant 3-D finish that enhances the light and dark tones of the same color.

For Best Results:

Before you begin, make sure you clean and prepare your walls and protect your furniture.  Refer to our how-to, "How to Prepare a Room for Painting" for more info.

BEHR PREMIUM PLUS with Style® Venetian Plaster should be applied only on primed surfaces or on surfaces previously painted with an Eggshell or lower sheen of paint.

Suggested Supplies

  • File
  • Vinyl Gloves
  • Protective Apparel
  • Rags
  • Steel Trowel
  • Stir Stick
  • Sandpaper
Step 1

The application items you'll need include a flexible 4" steel trowel, 100 grit and 400-600 grit sandpaper, a deep-well paint tray, and Behr Venetian Plaster and optional Venetian Plaster Topcoat.

Step 2

Begin by rounding the corners of a flexible steel trowel using 100 grit sandpaper to reduce edge marks during application.

Step 3

Load Behr Venetian Plaster onto the steel trowel and start at top corner of your wall. Holding a steel trowel at a 15 - 30 degree angle, spread a thin layer of Venetian Plaster onto the surface using long and short random strokes. The original wall surface should peek through in certain areas.

TIP:
Wipe off the steel trowel often to avoid dry bits of Venetian Plaster from affecting your pattern.
Step 4

Continue this process until the wall is completely covered.  Allow the first coat to dry for 4 hours before applying a second coat.

Step 5

Return to the original starting point (top corner) of your wall and apply a thin second coat of Venetian Plaster over the first coat. Hold the steel trowel at a 30-60 degree angle and use long and short overlapping strokes to achieve an irregular look to the final finish.

TIP:
Fill in voids and recessed areas while covering the original surface completely. Smooth away edge marks with a trowel.
Step 6

Continue this process until the entire surface is covered.

TIP:
Note: The colors used in this room are: On Thin Ice VC-11 and White Fur W-F-610