Smooth or rough-sawn exterior vertical wood surfaces such as Plywood, Fences, Shingles, Shakes, Siding and Laminates. Not for use on horizontal surfaces subject to foot traffic. Dry film will not harm livestock.
2-3 HR Dry Time 6-8 HR
200-500 Sq. Ft
Coverage per Gallon
Soap & Water
Proper surface preparation is required
Remove stains caused by mold and mildew with a mold and mildew stain removing product.
Previously painted, stained or clear sealed wood
Sand all glossy surfaces.
If surface is in good condition, apply directly over clean, dry surface.
If the latex or oil-based finish has started to crack, peel or flake, use a product such as BEHR PREMIUM® NO. 64 Wood Stain & Finish Stripper on wood to remove the coating. Rinse thoroughly.
Follow with a product such as BEHR PREMIUM NO. 63 All-In-One Wood Cleaner. Scrub, rinse, and allow to dry completely.
New, weathered, pressure treated or uncoated wood
Place cloth duct tape in random areas on the bare wood. Press the tape firmly then quickly remove it.
If wood fibers or debris are pulled onto the tape, the wood surface is not sound and additional preparation is required as follows: Clean surface with a product such as BEHR PREMIUM NO. 64 Wood Stain & Finish Stripper. Rinse.
Follow with a product such as BEHR PREMIUM NO. 63 All-In-One Wood Cleaner at full strength to remove mill glaze and/or loose wood fibers, dirt and other debris. Rinse and allow to dry.
Use when air and surface temperature are 50-90˚F (10-32˚C).
Do not apply in direct sunlight or if rain is expected within 24 hours.
Wood surfaces must be completely dry.
When working with more than one container of the same color, intermix to ensure color uniformity.
Redwood, Cedar, Cypress and other “bleeding” woods contain water soluble extractives which may cause discoloration of white and pastel colors; therefore prime the above type woods with one coat of a product such as BEHR PREMIUM PLUS® NO. 436 Exterior Multi-Surface Primer & Sealer to reduce these stains.
Apply with a nylon/polyester brush on smooth surfaces. On rough-sawn or textured wood apply with a 3/4" long nap roller or high quality airless sprayer. For airless spraying use a .015" tip. Keep a wet edge to reduce lapping and help control color uniformity.
Always back-brush or back-roll during all application methods.
Two coats may be necessary for complete hiding. Apply the second coat only after the first coat has thoroughly dried.
Longer dry time required in cooler temperatures and higher humidity.
For disposal of empty containers and unused product contact your household refuse collection service.
To consult with a Behr Certified Coatings Professional, call 1-800-854-0133 Ext. 2 (U.S.A. only).
LIMITED WARRANTY Behr Process Corporation warrants that this product meets Behr's manufacturing specifications. If this product does not meet these specifications, Behr Process Corporation will, at its option and upon proof of purchase, either furnish an equivalent amount of new product to you or refund the purchase price of this product. This warranty is made to the original residential product purchaser and is not transferable. This warranty excludes (1) labor and costs of labor for removal or application of any product or (2) any incidental or consequential damages, whether based upon breach of express or implied warranty, negligence, strict liability or any other legal theory. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.