Shopping Cart is Full

You cannot add any additional items to the Shopping Cart

Close Window

Site will log you out


You are leaving the BEHR® Consumer website. You will be logged out.



Ask an Expert by Email


Thank you,
Your email has been sent to our experts.



See all Interior paint how-to »

How to Create a Smooth Leather Finish

Skill:  Intermediate DIY'er

Add texture, depth and dimension to your accent walls and alcoves by applying a smooth leather finish to your walls.

For Best Results:

Mix the entire quantity of glazing color needed for the project before you start painting. Combining the contents produces uniformity in color. This intermixing is called "boxing."

 
Suggested Supplies
  • Vinyl Gloves
  • Paint Tray
  • Paint Tray Liner
  • Rags
  • Roller Cover and Frame
  • Stir Stick
  • Thin Plastic Sheeting
  • Bucket
  • Brush (Nylon/Polyester)
  1. Step 1

    Paint the base color and allow it to dry completely before glazing.

  2. Step 2

    To prepare your topcoat glaze color, pour 1 part PREMIUM PLUS ULTRA® or PREMIUM PLUS® paint and 4 parts FAUX GLAZE into a bucket and mix the contents thoroughly. For a more see-through or transparent look, add extra faux glaze to the mixture. For a denser or more opaque glaze color, add more paint to the mixture. The mixture will generally cover approximately 400 sq. ft.

  3. Step 3

    Pour your color glaze mixture into a paint tray and work a 6" mini roller into the glaze until it is fully loaded. To remove excess glaze, roll the tool on the ribbed area of the paint tray.

    TIP:
    Test your technique and color combinations on a practice board before you begin the project.
  4. Step 4

    Starting at a top corner of your project, roll the colored glaze onto a 3' x 3' section. Allow the glaze to set for 1 to 2 minutes.

  5. Step 5

    Cut plastic sheeting into squares that are slightly smaller than 3' x 3'. Scrunch up the plastic in your hands. Then, stretch it out and lay it gently over the wet colored glaze. Leave a wet edge.

  6. Step 6

    Using a brush, very softly brush over the plastic. Leave some wrinkles and overlapping. Avoid pressing with your fingers as this leaves finger marks.

  7. Step 7

    Leaving the plastic sheet in place, roll the colored glaze onto another section. Overlap it with the wet edge of the previous section. Apply a scrunched and stretched sheet of plastic onto this new wet area and repeat the process.

  8. Step 8

    Once the entire surface is covered, carefully peel away each of the plastic sheets to reveal the design.

  9. Step 9

    Repeat the process until the project is complete.