Shopping Cart is Full

You cannot add any additional items to the Shopping Cart

Close Window

Ask an Expert by Email


Thank you,
Your email has been sent to our experts.



See all Products »

BEHR PREMIUM® Protector & Waterproofer

BEHR PREMIUM® Protector & Waterproofer

Protect your home's concrete and masonry surfaces with BEHR PREMIUM Concrete & Masonry Protector & Waterproofer. This waterproofer is formulated with Silicone to penetrate into the surface to help keep water out and shield against salt damage and corrosion.

Finish
Natural Finish
Where to Use
Horizontal and Vertical uncoated Concrete and Masonry surfaces such as: Concrete Block, Pavers, Stucco, Brick, Unglazed Tiles, Exposed Aggregate Concrete, Sandstone and Slate.
Coverage
23 m2

Latest Featured Reviews

There are currently no featured reviews for BEHR PREMIUM® Protector & Waterproofer
SURFACES MAY BECOME SLIPPERY WHEN WET. USE CAUTION WHEN WALKING ON SURFACE WHEN MOISTURE IS PRESENT

Browse for Colours Online

Browse, coordinate and preview colours now, with ColourSmart by BEHR®.

Start Now »

Find a Store

Enter your Zip/Postal Code to find the nearest Home Depot

Where to Use

Horizontal and Vertical uncoated Concrete and Masonry surfaces such as: Concrete Block, Pavers, Stucco, Brick, Unglazed Tiles, Exposed Aggregate Concrete, Sandstone and Slate. Not recommended for use on areas subject to hydrostatic pressure such as basement walls or floors.

Usage Summary

Spread Rate
23 m2
24-48 Hr. to cure
Soap & Water
Clean-Up
Protect
from Freezing

Preparation

The following steps are recommended for best results.

  • New concrete must cure for a minimum of 30 days.
  • Remove old coating or sealer, if present, using a product such as BEHR PREMIUM® CONCRETE & MASONRY PAINT STRIPPER N0. 992. Follow all label instructions.
  • For proper penetration and adhesion, use a product such as BEHR PREMIUM® CONCRETE & MASONRY CLEANER & ETCHER NO. 991 to clean and etch the surface. Follow all label instructions.
  • TEST: Sprinkle a few drops of water onto the surface. If water is quickly absorbed, the surface is ready. If not absorbed, re-etch.

Application

  • DO NOT THIN. Stir or shake before applying.
  • Use product when temperature is between 10-32°C.
  • Apply until saturated by brush, roller or garden sprayer to a dry surface.
  • Remove any puddles by spreading product to drier areas or by wiping up excess with a clean cloth.
  • On vertical surfaces, apply from the bottom up and saturate well.

Dry Time

  • Once dried, rough, vertical surfaces may be coated with an oil or latex-based paint or primer. Follow all label instructions. Do not paint horizontal surfaces after applying this product.

Disposal

  • Clean all equipment immediately with warm, soapy water.
  • Properly dispose of all soiled rags and protect unused product from freezing.
  • For disposal of empty containers and unused paint, contact your household refuse collection service.

To consult with a BEHR Certified Coatings Professional, call 1-800-661-1591.

Other Products You May Like