Behr

Specialty Paints and Primers

FOR TINT BASE – DO NOT USE WITHOUT THE ADDITION OF TINTING COLORANT.

WHERE TO USE

Properly prepared Interior or Exterior vertical surfaces such as: Stucco, Masonry, Concrete, Concrete Block and Brick as well as adjacent Wood and Metal. Not for use on horizontal surfaces subject to foot traffic.

2-3 Hr Dry Time; 4 Hr Recoat Time

250-400 Sq. Ft Coverage per Gallon

Soap & Water Clean-Up

Protect from Freezing

PREPARATION

Proper surface preparation is required.

• Allow new stucco and masonry to cure for 30 days before painting.
• Remove all loose, peeling paint. Powerwash to remove chalk. Remove dirt and grease with a product such as BEHR PREMIUM® NO. 990 Concrete & Masonry Degreaser & Cleaner.
• Remove mildew stains with a mildew stain removing product.
• On galvanized metal, use a diluted solution of a product such as BEHR PREMIUM NO. 991 Concrete & Masonry Cleaner & Etcher to prepare the surface. Follow all label instructions. Rinse thoroughly and allow a minimum of 24 hours to dry.
• Cracks and gaps wider than 1/16" (1.5 mm) should be routed open, dusted and patched with a quality patching compound. Use an acrylic caulk around windows, doors and trim. Scuff sand glossy surfaces.
• If chalk remains on the surface, prime with a product such as BEHR PREMIUM PLUS® NO. 436 Exterior Multi-Surface Primer & Sealer.
• Prime all patched areas as well as adjacent wood and metal surfaces.
• If previously sealed or coated, check manufacturer's specifications before painting.

APPLICATION

• DO NOT THIN.
• Intermix all cans of same product to ensure color uniformity. Stir paint before and occasionally during application.
• Use product when air and surface temperature are 50-90˚F (10-32˚C). Do not use if rain or heavy dew is expected within 24 hours.
• Apply using a high quality 3/4"-1" nap roller, nylon/polyester brush or airless sprayer (.015"-.017" spray tip).
• Apply a second coat, if necessary. Maintain a wet edge to avoid lap marks.
• Do not re-spread or re-work paint.

DRY TIME

• Longer dry time required in cooler temperatures and higher humidity.
• After two weeks, cured paint film may be cleaned with a mild, non-abrasive liquid detergent.

DISPOSAL

• Properly dispose of all soiled rags.
• For disposal of empty containers and unused product contact your household refuse collection service.

WARNING!

WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

WARNING! Sanding or scraping pressure treated lumber may be hazardous; wear appropriate protection.

WARNING! This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm.

WARNING! IRRITANT! HARMFUL IF SWALLOWED. CONTAINS: ETHYLENE GLYCOL. MAY CAUSE EYE, NOSE AND THROAT IRRITATION. AVOID CONTACT WITH SKIN AND EYES AND AVOID BREATHING OF VAPORS AND SPRAY MIST. WEAR EYE PROTECTION AND PROTECTIVE CLOTHING. USE ONLY WITH ADEQUATE VENTILATION. To avoid breathing vapors and spray mist, open windows and doors or use other means to ensure fresh air entry during application and drying. If you experience eye watering, headaches or dizziness, increase fresh air. If properly used, a respirator (NIOSH approved for organic vapor with P series particulate prefilter) may offer additional protection; obtain professional advice before using. A dust mask does not provide protection against vapors. Avoid contact with eyes and skin. Wash thoroughly after handling. Close container after each use.

FIRST AID: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical assistance immediately. In case of eye contact, flush immediately with plenty of water for at least 15 minutes and get medical attention; for skin, wash thoroughly with soap and water. If swallowed, get medical attention immediately.

CAUTION: KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY.

LIMITED WARRANTY

Behr Process Corporation warrants your satisfaction with this product for 20 years on vertical surfaces from date of purchase, when applied to a properly prepared surface in accordance with the label directions. Color fading and chalking will occur naturally over time. If you are not satisfied with this product, Behr Process Corporation will, at its option and upon proof of purchase, either furnish an equivalent amount of new product or refund the purchase price. This warranty is made to the original residential product purchaser and is not transferable. This warranty excludes (1) labor and costs of labor for removal or application of any product or (2) any incidental or consequential damages, whether based upon breach of express or implied warranty, negligence, strict liability or any other legal theory. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.

To consult with a Behr Certified Coatings Professional, call 1-800-854-0133 Ext. 2 (U.S.A. only).