Behr

Paints

FOR TINT BASES - DO NOT USE WITHOUT THE ADDITION OF TINTING COLORANTS

WHERE TO USE

Properly prepared and cleaned coated or uncoated exterior surfaces. Ideal for Wood, Vinyl,Aluminum, Fiber Cement Siding,Metals, Steel, Doors, Windows, Trim, Shutters, Garage Doors,Outdoor Furniture, Railing and Wrought Iron.

2 HR Dry Time; 4 HR Recoat Time

250-400 Sq. Ft. Coverage

Soap & Water Clean-Up

Protect from Freezing

PREPARATION & PRIME

• Countersink nailheads, fill and sand smooth. Remove rust, loose or peeling paint. Repair imperfections and sand smooth.
• Wash off dirt, grease and chalk with detergent and/or powerwash. Remove mildew stains with a mildew stain removing product.
• Clean and sand new or weathered wood. Scuff sand or degloss smooth or glossy surfaces.
• Scuff sand or etch metals. Rinse and allow to dry.
• Caulk windows, doors and other openings. Allow new stucco, plaster and masonry to cure for 30 days before painting.
• Use BEHR PREMIUM PLUS ULTRA® paint as a primer for repaired or uncoated surfaces, including woods that contain tannins (two primer coats required for redwood and cedar) and heavily stained areas.
• Lock in stains with the first primer coat; if necessary, apply a second primer coat of BEHR PREMIUM PLUS ULTRA.
• For drastic color changes or when applying deep colors denoted with a dagger (†) on the color chip, apply a tinted primer coat of BEHR PREMIUM PLUS ULTRA if needed.

APPLICATION

• Apply product on dry substrates when air and surface temperatures are between 35°-90°F (2°-32°C) and will remain between 35°-90°F (2°-32°C) for at least 4 hours after applying.
• Do not paint when rain or heavy condensation is expected.
• Stir paint occasionally. Intermix containers of same product to ensure color and sheen uniformity.
• On semi-smooth surfaces, use a high quality 3/8-1/2” nap roller cover, nylon/polyester brush or an airless sprayer (.015-.021” spray tip, 60 mesh filter).
• On rough surfaces, use a high quality 3/4-1” nap roller cover.
• Do not thin if using a roller or brush; however, if using a sprayer and thinning is required, thin with water at a rate of no more than 1/2 pint per gallon.
• Certain colors may require more than one coat for complete hide.
• On heavy stains and woods that contain tannins, allow 12-16 hours of dry time between coats. Cooler temperatures or higher humidity may prolong drying time.
• After 4 weeks, cured paint film may be cleaned with a mild, non-abrasive liquid detergent.
• Dry paint film is mildew resistant.
• When applying to vinyl, color choice must be the same color or lighter than the existing color. Do not use on floors.

DISPOSAL

• For disposal of empty containers, unused paint and soiled rags, contact your household refuse collection service.

Visit behr.com for painting tips, expert project advice and the perfect color coordination with COLORSMART BY BEHR™.

WARNING!

If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

WARNING! This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm.

WARNING! IRRITANT! HARMFUL IF SWALLOWED. CONTAINS: ETHYLENE GLYCOL. MAY CAUSE EYE, NOSE AND THROAT IRRITATION. AVOID CONTACT WITH SKIN AND EYES AND AVOID BREATHING OF VAPORS AND SPRAY MIST. WEAR EYE PROTECTION AND PROTECTIVE CLOTHING. USE ONLY WITH ADEQUATE VENTILATION. To avoid breathing vapors and spray mist, open windows and doors or use other means to ensure fresh air entry during application and drying. If you experience eye watering, headaches or dizziness, increase fresh air. If properly used, a respirator (NIOSH approved for organic vapor with P series particulate pre-filter) may offer additional protection; obtain professional advice before using. A dust mask does not provide protection against vapors. Avoid contact with eyes and skin. Wash thoroughly after handling. Close container after each use.

FIRST AID: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical assistance immediately. In case of eye contact, flush immediately with plenty of water for at least 15 minutes and get medical attention; for skin, wash thoroughly with soap and water. If swallowed, get medical attention immediately.

CAUTION: KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE INTERNALLY.

*LIMITED LIFETIME GUARANTEE

Behr Process Corporation guarantees your satisfaction with the performance of this paint when applied to a properly prepared surface and cared for according to the label directions. This guarantee shall be effective for so long as you reside in your home and is made to the original residential consumer paint purchaser. This guarantee is not transferable. if you are not satisfied with this paint's performance, Behr Process Corporation will, at its option and upon proof-of-purchase (the original receipt), either furnish an equivalent amount of paint or refund the purchase price of this paint to you. This guarantee excludes (1) labor and cost for the application or removal of any product and (2) any incidental or consequential damages, whether based on breach of express or implied warranty, negligence, strict liability or any other legal theory. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This guarantee give you specific legal rights and you may also have other rights, which vary from state to state.

To consult with a BEHR Certified Coatings Professional, call 1-800-854-0133 Ext. 2 (U.S.A. only).