How to apply BEHR PREMIUM® 1-Part Epoxy Concrete & Garage Floor Paint
A high-performance, ready-to-use, water-based epoxy floor paint that resists hot tire pick-up and marring.
For best results:
Before you apply the coating to any concrete surface, it is essential to have a properly cleaned and prepped surface.
For new or uncoated surfaces, refer to: Preparation of Uncoated Concrete for Paints & Stains
For previously coated or weathered surfaces, refer to: Preparation of Coated Concrete for Paints & Stains
To add a topcoat, refer to: Apply BEHR Premium 1-Part Epoxy Concrete & Garage Floor Paint top coated with BEHR Premium Wet-Look Sealer.
Tools & supplies
- Bucket
- Broom (Stiff Bristle)
- Brush (2"-2½")
- Bucket Grid
- Chemical Resistant Gloves
- Extension Pole
- Hose
- High Pressure Nozzle
- Mop
- Paint Can Opener
- Paint Tray
- Paint Tray Liner
- Protective Apparel
- Pump Sprayer
- Rags
- Roller Cover
- Roller Frame
- Stir Stick
Step-by-step process
How to coat a garage floor
Step 1
Once the surface is cleaned, prepped and primed, apply the epoxy floor paint. Make sure to stir the paint before applying. Apply a thin, even layer using a 3/8" nap roller cover, a pad applicator or a nylon-polyester brush.
Step 2
Cut-in using a brush to coat the perimeter of the surface area that is next to the wall.
Step 3
Apply the stain, using long even strokes. Apply in one direction to avoid lap lines. Apply the stain when air and surface temperatures are between 50-90 degrees F. Since concrete varies in texture and porosity, 2 coats may be required for uniform appearance.
TIP: The spread rate on a rough surface is approximately 300-400 sq. ft and on a smooth surface, 400-500 sq. ft.
Step 4
Allow the first coat to dry for at least 4-6 hours before re-coating, if necessary. Apply the second coat in a criss-cross direction for uniformity of appearance. Do not apply more than 2 coats.
TIP: Use soap and water for any clean-up.
Step 5
The surface must be fully cured before use.
TIP: Premature heavy traffic will cause paint failure which will require spot re-coating. If necessary, corrugated cardboard may be placed under auto tires after 72 hours.