BEHR^® Oil-Latex Redwood Stain

Where to UseBlank space if empty.

Exterior new or properly prepared wood surfaces such as: Fences, Siding, Planters and Wood Patio Furniture. Not intended for horizontal surfaces subject to foot traffic.

Usage SummaryBlank space if empty.

PreparationBlank space if empty.

The following steps and products are recommended for best results.

• Use a product such as BEHR PREMIUM® NO. 64 Wood Stain & Finish Stripper to remove loose wood fibers, latex, oil-based and 100% acrylic coatings on new or weathered wood.
• BEHR PREMIUM® NO. 63 All-In-One Wood Cleaner MUST be used following NO. 64 to clean, brighten & neutralize wood.
• When NO. 64 is not needed, use a product such as NO. 63 to clean and brighten the wood surface and to remove light to medium exterior stains caused by mold, mildew, algae & fungus. Rinse thoroughly and allow to dry before coating.
• On new wood, use a product such as NO. 63 to remove mill glaze and open the pores of the wood. Lightly sand any remaining wood fibers/fuzz.

ApplicationBlank space if empty.

• Must apply between 40-90˚F (4.5-32˚C). Do not use if rain is expected within 24 hours.
• Intermix multiple containers to ensure color uniformity. DO NOT THIN PRODUCT.
• Stir product occasionally throughout application. Avoid applying stain in direct sunlight or to hot surfaces.
• Apply with a natural bristle brush or pad applicator. On rough surfaces apply with a 3/4" long nap roller or high quality airless sprayer using a .015 - .019" tip.
• Follow spraying immediately with back-brushing or back-rolling for a uniform appearance.
• Two coats may be applied, however a more solid color appearance will result.
• Over application of stain will lead to surface failure including peeling and cracking.
• Avoid applying stain too heavily.

DisposalBlank space if empty.

• For disposal of empty containers and unused product, contact your household refuse collection service.