BEHR® Metal Primer

30 Min Dry Time
1 Hour Ready to Topcoat

Up to 450 Sq. Ft. Coverage per Gallon

Soap & Water Clean-Up

Protect From Freezing

• Over properly prepared uncoated and previously painted Interior/Exterior ferrous and non-ferrous metal surfaces.
• Ideal for ferrous metal surfaces, such as: Steel, Carbon Steel, Stainless Steel, Cast Iron, Wrought Iron, Galvanized Steel; and non-ferrous metal surfaces, such as: Brass, Aluminum, Copper, Lead, Nickel, Tin, Titanium, Zinc and Metal Alloys.

Preparation

• All surfaces must be properly prepared, cleaned and primed on the same day.
• Remove all loose or peeling paint; wash off chalk, dirt and grease with mild detergent, rinse well and allow to dry.
• Remove mildew stains with a mildew stain removing product.
• Scuff sand glossy surfaces and repair imperfections.
• Remove all loose dust and rust particles with a wire brush and dry cloth.
• In some cases, scraping or sanding may be needed to allow the primer to adhere.
• Do not use if surface is structurally unsound or severely deteriorated.

Application

• Apply when air and surface temperatures are between 50-90°F (10-32°C).
• Use a high quality 1/4 - 3/8" nap roller cover, nylon/polyester brush or an airless sprayer (.011"-.017" spray tip, 60 mesh filter)
• Stir primer occasionally.
• Do not thin if using a roller or brush; however, if using a sprayer and thinning is required, thin with water at a rate of no more than 1/2 pint per gallon.

Disposal

• For disposal of empty containers, unused paint and soiled rags, contact your household refuse collection service.