Slide 1 of 10
Slide 2 of 10
Slide 3 of 10
Slide 4 of 10
Slide 5 of 10
Slide 6 of 10
Slide 7 of 10
Slide 8 of 10
Slide 9 of 10
Slide 10 of 10

Slide 1 of 10

BEHR® Flocked Foam 4” Rollers

Starting at

Experience a smooth, professional finish with BEHR Flocked Foam rollers, perfect for cabinets, doors, and trim. They deliver a spray-like result, with flocked fibers that minimize bubbling* for a smooth and even finish. Plus, they cover more area than traditional high-density foam rollers, helping you to complete your project faster.

Buy at The Home Depot

Features you'll love

Creates spray like finish
Minimizes bubbling
Shed resistant

Available Sizes: 4” roller with frame and 4” roller 2pk refill

To Use:

Ensure 4” roller is attached to 4" wire frame
Leave a ¼” gap between roller and frame for smooth spinning.
Before painting, remove loose fibers from roller by rolling it over low-tack painter's tape. Watch how-to video here.
Dip the roller into the paint-filled tray or bucket, then roll it over the ribbed section of the tray or grid to remove excess paint and prevent dripping.
Continue this process for 10 to 15 seconds, dipping and rolling until the roller is fully saturated.
Use an extension pole for wall painting, if desired.
Start painting on substrate with long vertical strokes.
Roll with moderate pressure until paint stops releasing. Avoid heavy pressure.
Reload roller and overlap each new section with the previous one.

To Clean:

Remove cover from frame immediately after use.
WATER-BASED PAINTS: Wash in warm soapy water, rinse, dry.
OIL-BASED PAINTS: Rinse in manufacturer's recommended solvent. Wash in warm soapy water, rinse, dry.
DO NOT SOAK IN WATER OR SOLVENT.