BEHR ULTRA^™ Stain-Blocking Ceiling Paint

Properly prepared coated and uncoated Interior Ceilings.

• Remove loose paint, wash off any dirt and grease with detergent, remove mildew stains with a mildew stain removing product.
• Scuff sand glossy surfaces.
• Countersink nailheads, repair imperfections and sand smooth.
• Remove all dust with a damp cloth, allow to dry.
• Allow new stucco, plaster and masonry to cure for 30 days before priming.
• Make sure that there are no active water problems and that any previous water damage is fully dry.
• Use BEHR ULTRA™ STAIN-BLOCKING CEILING PAINT as a primer for repaired or uncoated surfaces.
• Lock in stains with BEHR ULTRA STAIN-BLOCKING CEILING PAINT as a spot primer. For heavy stains, test for stain bleedthrough by applying BEHR ULTRA STAIN-BLOCKING CEILING PAINT as a topcoat to a small section. If the stain bleeds through the topcoat, spot prime another coat to the stained area and test again before topcoating the entire ceiling. If bleeding continues, a longer dry time is needed before topcoating. Additional coats may be needed to achieve hide.
• For drastic color changes, apply a primer coat of BEHR ULTRA STAIN-BLOCKING CEILING PAINT if needed.

• Use product when the surface and air temperatures are between 50-90°F (10-32°C).
• Stir paint occasionally. Intermix containers of same product to ensure color and sheen uniformity.
• Use a high quality 3/8-1/2” nap roller cover, nylon/polyester brush or an airless sprayer (.015-.019” spray tip, 60 mesh filter).
• Popcorn style acoustic ceilings; use acoustic ceiling roller cover (1/2-3/4” nap) or airless sprayer (.015-.019” spray tip, 60 mesh filter).
• Coverage is 250-400 sq. ft. (23-37 m2) per gallon depending on the surface texture, porosity and application method.
• Do not thin if using a roller or brush; however, if using a sprayer and thinning is required, thin with water at a rate of no more than 1/2 pint per gallon.
• Multiple coats may be required to complete hide.

• Dries to touch in 30 minutes at 77°F (25°C) and 50% humidity, re-coat in 1 hour.
• Longer dry time required in cooler temperatures and in higher humidity.

• Use soap and water.
• Properly dispose of all soiled rags and protect unused product from freezing.
• For disposal of empty containers and unused product, contact your local household refuse collection service.